UAE Dirham
One component and ready to use moisture curing polyurethane foam mainly used for sealing of insulation sheets, filling of joints and cavities in walls and ceilings. Closed cell structure, resistant to water absorption. Excellent thermal insulation characteristics and very good acoustic characteristics. Suitable for sealing high volume low movement gaps. CFC free.
Application:
Fixing and insulation of door and window frames.
Filling and sealing gaps, joints and cavities.
Filling of penetrations in walls.
Insulating electrical outlets and water pipes.
Instructions:
Optimal can temperature is +20 Deg.C . Application (ambient) temperature is between +5 Deg.C to +30 Deg.C . Shake the can well before use. Screw the tube on the valve. Moisturizing the surfaces and the foam improves adhesion and shortens curing time. Hold the can upside down and activate the foam by pressing the valve. When spray please pay attention to the speed. Fill vertical joints from the bottom up when half filled enough. When fill gaps in ceiling, uncured foam may drop because of gravity, Fresh foam can be cleaned by acetone immediately. Please support properly after filling until foam cure and adhere to the gap. Foam is tack free after about 10 minutes, can be cut after 60 minutes. Use a knife to smooth the cured foam and treated surface with cement, paint or silicone.
Restrictions:
Storage above +30 Deg.C and below -5 Deg.C shortens shelf life.
Should be stored and transported in vertical position.
Should be kept in room temperature for at least 12 hours before the application.
Cured foam will discolour if exposed to ultraviolet light.
Paint or coat the cured foam for best results in outdoor applications.
Storage And Shelf Life:
12 months when stored at 20 Deg.C / 50% relative humidity out of direct sunlight.
Safety:
Contains Diphenylmethane-4,4'-Diisocyanate. Harmful by inhalation. Irritating to eyes, respiratory system and skin. Do not breathe spray/vapour. Wear suitable protective clothing and gloves. Use only in ellventilated areas. Pressurized container. Keep away from direct sunlight and do not expose temperatures over 50 Deg.C . Do not pierce or burn, even after use. Keep away from sources of ignition, no smoking. Keep out of the reach of child.
- 300% - Triple Expanding Foam
- Excellent adhesion & filling capacity and high thermal & acoustical insulation valve
- Excellent mounting capacity and stability
- Adheres to almost all building materials with the exception of surfaces such as polyethylene, Teflon, silicone and surface contaminated with oils and greases, mold release agents and similar materials
- Mould proof, water proof, over paintable
- Quick drying, moisture curing
- Closed cell structure, resistant to water absorption
- Cured foam dries rigid and can be trimmed, shaped and sanded
- Suitable for sealing high volume low moment gaps
- It does not contain any propellant gases that are harmful to the ozone layer
